LHM-B Ceramic Media Ball Mill Classifying Production Line
The material is lifted by bucket lifter into the hopper, then transported to ball mill by feed conveyor controlled by frequency reducer, the ground material is sucked to the Self-diffluent classifier, where the coarse and fine powders is separated by the centrifugal force and draft force, the qualified powder is collected by collector and the oversized particle is resend to the ball mill by screw conveyor.
--- Produced in negative pressure, equipped with suction pipe,which can not only eliminate dust in ball mill production line,but also effectively used energy,reduce energy consumption and clean the environment.
--- Low consumption, the consumption of completely line discreased 30-50% compared with traditional production process.
--- Optimized internal design for ball mill,the capacity increased 40% ,energy consumption discreased 40% to compare with tradition ball mill.
--- The output rate of finished product can reach more than 85%,increased 50% compared with others.
--- Particle size can be adjusted,it can be produce 50mesh to 325mesh in difference industries.
--- The flow chart designed is scientific,human factore have little influence under operation process.
--- Intelligent control, operate easily, less person effect to equipment.
--- Adopted with high-concentration phase self-diffluent classifier,the processing capacity of singal classifier can reach 100t/h.Energy consumption is 50% lower than others under the same handling capacity.
--- Optimized internal design for ball mill,the capacity increased 40% ,energy consumption discreased40% to compare with tradition ball mill.
--- The flow speed of material in ball mill can be controlled,and the circulation quantity can be adjusted.
--- The grinding media is selected the same/similar materials composition according to difference materials to avoid the pollution of finished product,ensure the purity of product.
--- The superfine ball mill has been ninovatively designed on the basis of original,which improve the grinding efficiency,scientific grinding mix ratio which can be adjusted to grade as required.
--- Adopted with high-concentration phase self-diffluent classifier,energy consumption is 50% lower than others under the same handling capacity.
--- High classification accuracy,accurate cutting point,control the coarse particle size strictly.
--- High classification efficiency,The extraction rate of fine powder higher than others under the same handling capacity,and the content of fine powder is less than 5% for feedback.
--- Advanced low-speed structure design ,the classifying wheel is adopted with ceramic composite material.
--- Advanced high concerntration phase classifying technology,the unit air volume of material is 3-5times compared with vertical and horizontal classifiers,and the handling capacity of single machine can reach 100t/h.
It is widely used in high purity and ultrafine processing of quartz, feldspar,zircon sand, zirconium silicate, α-alumina,ceramic material, luminescent material, electronic material and fireproof material etc.